You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Australia & New Zealand Homebrewing Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
The Recipes that G&G had under the ArtisanAle brand were really fantastic but the reality is that these recipes were public. If the...
-
https://www.kegland.com.au/products/red-ball-lock-plastic-carbonation-cap-x-6-35mm-duotight...
-
To keep the instruction manual simple we say use the two point calibration method with 1.000 being one calibration point and 1.040-1.060...
-
I have been told by a flavor technologist that Buderim have been generally moving towards growing fresh ginger and what is called "new...
-
Yes that is correct. This is a much better process.
Your previous calibration points of 1.000 and 1.004 are way too close together...
-
Can you send us a photo of the pill in the fermenter?
-
With respect to the RAPT Pill Hydrometer generally speaking it's highly accurate once you do the two point calibration process but this...
-
Ok I see. This looks pretty simple to make so we will draw something up now and find out what the cost would be.
-
https://www.kegland.com.au/products/1-5-inch-tri-clover-with-1-2-female-thread-bsp?currency=AUD&variant=43494941786368&utm_medium=cpc&utm...
-
Yes if you are changing the wiring and putting the KSD301 in series then you need to make sure you choose the model that is rated for at...
-
All of the current ratings will work. We have very low current through this device as the thermal breaker is wired to the low voltage...
-
Yes it's best to use a check valve or plug the hole somehow. It's possible for wort to gradually seep into the stone.
-
Sorry we have been going back and forth with design quite a lot on this and the delays have been substantial. I am sorry but we thought...
-
Here is the specification sheet here:
https://www.calcoelectric.com/images/pdfs_thermostats/calco_ksd301series.pdf
-
Even if you do source the can's locally I would recommend purchasing the lids from us as the B64 are much easier to seam and use. The...
-
Loading…
-
Loading…
-
Loading…
-
Loading…