Search results

Is the a way to ballpark the throughput of a given mill at a given speed? :huh: I'm running a monster MM3, Three rollers, six inches long, two wide. Proposed motor turning at 120 RPM.

I'm the proud owner of a Monster mill MM-3 PRO, 3x 2 inch rollers. Up until this point I been struggling along with my drill but the grain group buy fast approaching and I'd like a better solution in place to deal with the mass of grain coming. Very interested in the motor and speed controller...

In my search for mills I thought it was odd there weren't any German ones, what with the Germans being fiercely proud beer makers and known for good engineering. After much searching I found this interesting design. It has rollers 2.75 inches in diameter but only 2 inches wide. Been reading...

After much reading and hard thought I'm settling in on the mash master mini. It seems the most reputable. The combination of geared and ss rollers have just about sealed the deal. I would have liked a 3rd roller but there don't seem any using more than one powered roller? Obviously this system...

The other day my chugger burnt out. It was horrible, started smoking and was crazy hot. Not sure why it happened, I wasn't running it dry and I keep it clean. The only thing I can think of was that I was running through an extention cord, which I have recently read can cause problems. Anyway so...

Hi guys, great forum you have here. Firstly in the interest of full disclosure I haven't made any actual beer yet, although I have been been doing AG mashes for distilling for a number years now. It's always been my intention to complete my alcohol independence with my own beer but life is...