Recent content by rotamoulding

no there is no holes beside the lid or 25mm outlet. however we can drill and tap anywhere in the side wall to provide and outlet with sufficient thread to use

The main cone bit is at 90 deg acute angle (45deg) freight door to door via TNT is $40 to Melbourne Metro Regards Troy

We now have these tanks available for sale Special price for brewing - 15L $110 (RRP $143), 30L $140 (RRP $198) The lid is seal with an o-ring and can handle 15 psi, the bottom is threaded to 25mm 15lt - Height - 490mm 30lt - Height - 770mm

Mold is made and the first one was made today There will 2 sizes , this one that is around 15lt 500mm heigh x 300mm in diam and a 35lt version that is 800mm heigh and same diam, the cone section will remain the same just the middle gets longer we could make another longer section if people...

At Best the tank will hold 5 psi, I am thinking

Hello, Troy from Rota moulding here, We are going ahead with a 35lt Cone bottom tank mould it will be around 700 - 800mm high and 300mm in diameter the lid idea we have is a screwed with oring 170mm opening to allow you to get in and clean it How much pressure is the tank under in the process...

No haven't forgotten, just busy. I had an email from someone here I think and this has got me thinking, I am planning to build a mould next month and would like some feedback Bassicly its a new 40lt Cone bottom 300mm diameter x around 800mm high the bottom of the cone will have a small flat...

Hello, I am Troy Coulthard - Sales Manager of Rota Moulding WA I was looking at my web page statistics and came across this site. If there is any information I can provide or you have any idea's for me, I am all ears I was always was under the impression that you needed a totally sealed tank for...