Recent content by Neolithic

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. N

    Brewer's Friend Premium Membership Giveaway

    I’m in would love this
  2. N

    The Brauduino (Matho’s Controller) Build/Advice/Question Thread

    Hi finally got both of my units fully wired up for 240v power etc. They both work now but the previous issue one reads about 20C higher temp than the other. Any ideas? Can you recalibrate 0 and 100c in the settings if so I can’t find it. Or do you think I may have an issue with the temp probe...
  3. N

    The Brauduino (Matho’s Controller) Build/Advice/Question Thread

    I have swapped the Mega’s over between my good box and both work normally in the good box. I think I must have a duff shield / screen. Matt
  4. N

    The Brauduino (Matho’s Controller) Build/Advice/Question Thread

    Hi guys, finally got round to building my second Lael controller last week. None of the 240v is wired so basically a layout build with buttons temp sensor. When I power up off a usb cable it boots into ardbir the after a few seconds the screen contrast goes and the screen goes off as do the...
  5. N

    Matho's controller

    Hi guys built my second controller tonight. Not done the 240v wiring side yet. This one has a problem. When you power up from usb it boots into ardbir etc then the screen contrast starts to fade out and the screen goes blank. The mega leds also stop so its as if the power is fading out. Mega is...
  6. N

    The Brauduino (Matho’s Controller) Buy thread

    Would like to get one of these shipped to the UK any left or anymore being made? Matt J
Back
Top