Recent content by jmarkey

gimme gimme gimme!!!!

G'day Gava Thanks for that. For the moment I will do as you suggested and tape the probe + insulation to the side of the fermenter (if the same reading as on top of the lid) as see how that goes. I might then do the direct injection method (probe into the wort) and do a comparison (got to get...

G'day all Been reading up where the best position to locate your TempMate probe in the fridge would be..Well, I have chucked my probe in a glass of sugared water next to my fermenter and I was wondering whether this will affect the probe over a period of time or would it be advisable to get a...

G'day SpillsMostOfIt Thanks very much for that info re: route it through the condensation drain. I will give that a go first and if that fails then I will resort to the seal 'n' frame method. I also neglected to ask about the heating element wires, would you employ the same method going through...

G'day All Ok, just purchased the Tempmate temperature control unit and have just finished wiring it up...but I was wondering whether I will have to drill holes in the fridge to insert the probe unit or have the probe wires hanging out of the fridge door - which I am trying to avoid??? If there...