Recent content by jimidee

Hey Simon, I have a Barley Crusher and it is set at the factory 0.39". The rubber o ring that drove the second roller has long gone, however I don't have any problem when I run my malt through. The 'slave' roller rotates perfectly due to the grain flowing though. I would think that either you...

Thanks Doc, I have emailed Damo to see what he can do. It is amazing how fast things happen when one starts asking around. I have found that the local BrewCraft agency stocks the 'mushroom' washers for the gas and dispensing post poppets, as well as the washer for the dispensing (long) tube...

I have been searching for the right type of poppets for a dozen kegs I picked up from Coke Amatil in NZ a number of years ago. The poppets are totally different from those shown on this subject so far in that they do not have the 3 leg component at the bottom of the shaft. They have a circular...