Temp D I Y

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

altstart

Well-Known Member
Joined
23/5/05
Messages
480
Reaction score
3
;)

vlbaby your setup is very impressive, the timer is abit of wank factor not really required. The bits you don't see on mine are the powerpoints and power supply. I think I might have to start on the next version that is a bit neater on the back.

Goat, the thing under the strap is the temp sensor for the brew, it is insulated from the ambient air to give a more acurate reading. I tried a probe in the brew but it proved to be too much of a hassle.

anyway here is the pcb, circuit and code.

Cheers

Attached File(s)
Attached File vx4_nest.pdf ( 26.92k ) Number of downloads: 36
Attached File vx4_nest_brd1.pdf ( 26.5k ) Number of downloads: 30
Attached File vx4_nest_brd.pdf ( 56.04k ) Number of downloads: 23
Attached File VX4_MKII_ver3.txt ( 16.1k ) Number of downloads: 34

Gooday
Any one built one of these Temp Controllers from the above genorous post by Gizzbrew. I note it uses a Pic 16F628 but IC2 and IC3 are not identified. Can anyone identify them.
Thanks Altstart
 

Latest posts

Back
Top