droid
somewhere on the slippery slope with a beer in han
Hi all,
I have one of the common soda stream adapters. It is fitted to my KK regulator and the soda stream bottle fits the other end.
My regulator came with a plastic spacer cable tied to it. I can't remember if the KK adapters come with this spacer too.
The first time I used the SS bottle I didn't use the seal inside the adapter where the bottle meets and it leaked but I managed to tighten it up enough.
Next time I used the seal and it was better.
This time I used the seal and couldn't get the pin to push down on the bottle and release the c02. Like the spacer was too thick - maybe I didn't use the right one?
I took it off and tried without it and as tight as it was, it still leaked. I have been putting gas tape on the thread but not too much.
I tried to undoo the bottle as it was leaking but was worried about blowing my arm off. C02 was spitting out and hissing...
Can you simply untwist these bottles when they are full?
Is it just a matter of undoing past the scary release point?
Can someone help me make this easier, I really don't like compressed gas/air - it gives me the willies
cheers
I have one of the common soda stream adapters. It is fitted to my KK regulator and the soda stream bottle fits the other end.
My regulator came with a plastic spacer cable tied to it. I can't remember if the KK adapters come with this spacer too.
The first time I used the SS bottle I didn't use the seal inside the adapter where the bottle meets and it leaked but I managed to tighten it up enough.
Next time I used the seal and it was better.
This time I used the seal and couldn't get the pin to push down on the bottle and release the c02. Like the spacer was too thick - maybe I didn't use the right one?
I took it off and tried without it and as tight as it was, it still leaked. I have been putting gas tape on the thread but not too much.
I tried to undoo the bottle as it was leaking but was worried about blowing my arm off. C02 was spitting out and hissing...
Can you simply untwist these bottles when they are full?
Is it just a matter of undoing past the scary release point?
Can someone help me make this easier, I really don't like compressed gas/air - it gives me the willies
cheers