Help Support Aussie Homebrewer by donating:

Selling some old gear - Copper immersion chiller, font tower, drip tray, decal holders

Discussion in 'Buy and Sell' started by Mat B, 14/8/18.

 

  1. Mat B

    Well-Known Member

    Joined:
    22/4/10
    Messages:
    212
    Likes Received:
    65
    Gender:
    Male
    Location:
    Greensborough
    Posted 14/8/18
    Copper chiller - $20
    Font tower - $10
    Drip tray (plastic & stainless) - $10
    Decal holders - $5 for both

    Located in NE burbs of Melbourne.

    IMG20180814113900.jpg IMG20180814115209.jpg
     
  2. Hangover68

    Well-Known Member

    Joined:
    12/7/17
    Messages:
    111
    Likes Received:
    41
    Gender:
    Male
    Location:
    St Helena, Melbourne NE.
    Posted 14/8/18
    Mat, i'll take the font tower , drip tray and decal holders.

    regards,
    Nick.
     
  3. Mat B

    Well-Known Member

    Joined:
    22/4/10
    Messages:
    212
    Likes Received:
    65
    Gender:
    Male
    Location:
    Greensborough
    Posted 15/8/18
    Just the chiller left now.
     
  4. jsp1511

    Member

    Joined:
    17/7/14
    Messages:
    8
    Likes Received:
    1
    Posted 16/9/18
    Still available? And ideas if it would fit in a cooper fermenter?

    Also assuming to clean it before dropping in a brew I would just soak it in sanitiser?
     
  5. Mat B

    Well-Known Member

    Joined:
    22/4/10
    Messages:
    212
    Likes Received:
    65
    Gender:
    Male
    Location:
    Greensborough
    Posted 20/9/18
    Yep, still available! Not sure if it would fit in the fermenter, but you could always modify it. It might fit. I usually just give it a hose down before adding to the brew. The boil sanitises it. I never put it in the fermenter. Goes into the brew pot.
     
    Garagebrew likes this.

Share This Page