Re-Hydrating Yeast

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

bL@De

Well-Known Member
Joined
6/12/02
Messages
112
Reaction score
3
It was recommended to me I should rehydrate the yeast before using, I had no problems with this as I'm fully open to suggestions anyway I have attempted this twice so far and each time the yeast eventually goes to the bottom of the container and dies.

What am I doing wrong I keep asking myself.

Here's what I am doing:
Place about 1/3 cup of water in small bowl (40 degrees C)
1/2 teaspoon of sugar into the water and stir to dissolve
Place the packet yeast in and stir

I believe I have the right instructions but where I am going wrong I don't know but I have a sneaking suspicion it could be the temperature of the water as yeast dies above 30 degrees or something doesn't it?

TIA
 
I don't rehydrate dry yeast above 30C, and I never place any sugar with the water. Doing so seems to be a waste of effort due to the fact that rehydrating yeast will take about 1/2 an hour, and any sugar placed in the water simply wont be utilised in that time.

So in future, fill a coffee mug with 30C water, sprinkle the yeast on the surface, let it sit for about 20 - 25 minutes, THEN stir and pitch the slury into your wort. There's not much more too it than that.

Cheers,
Pete
 
I would be inclined to agree with pete on this. If you are going to rehydrate you should not leave it for much more than half an hour. As it is though we overpitch our yeast at a rate of about 500+ percent over what the manufacturers recommend for breweries(reference http://www.dclyeast.co.uk/ ). I dont think that at the temperatures that we use that it is of any advantage to hydrate yeast at all.

Cheers,

Rainman :chug:
 
Information on rehydrating yeast. Info was provided to a brewer by Dr Cone, from Lallemand. I think this info originally appeared on the HBD list.

cheers
reg

------------------------------------
My question to Dr. Cone regards yeast rehydration. All the packages of
yeast contain instructions for rehydration yet they all ferment just fine
without it. I have to believe that such a procedure may be theoretically
beneficial, however it would seem to be margionally usefull at least on a
homebrew scale.

Let me give you some facts regarding rehydration and you can decide for
yourself where you want to compromise.

Every strain of yeast has its own optimum rehydration temperature. All of
them range between 95 F to 105F. Most of them closer to 105F. The dried
yeast cell wall is fragile and it is the first few minutes (possibly
seconds) of rehydration that the warm temperature is critical while it is
reconstituting its cell wall structure.

As you drop the initial temperature of the water from 95 to 85 or 75 or 65F
the yeast leached out more and more of its insides damaging the each cell.
The yeast viability also drops proportionally. At 95 - 105 F, there is
100% recovery of the viable dry yeast. At 60F, there can be as much as 60%
dead cells.

The water should be tap water with the normal amount of hardness present.
The hardness is essential for good recovery. 250 -500 ppm hardness is
ideal. This means that deionized or distilled water should not be used.
Ideally, the warm rehydration water should contain about 0.5 - 1.0% yeast
extract.

For the initial few minutes (perhaps seconds) of rehydration, the yeast
cell wall cannot differentiate what passes through the wall. Toxic
materials like sprays, hops, SO2 and sugars in high levels, that the yeast
normally can selectively keep from passing through its cell wall rush right
in and seriously damage the cells. The moment that the cell wall is
properly reconstituted, the yeast can then regulate what goes in and out of
the cell. That is why we hesitate to recommend rehydration in wort or
must. Very dilute wort seems to be OK.

We recommend that the rehydrated yeast be added to the wort within 30
minutes. We have built into each cell a large amount of glycogen and
trehalose that give the yeast a burst of energy to kick off the growth
cycle when it is in the wort. It is quickly used up if the yeast is
rehydrated for more than 30 minutes. There is no damage done here if it is
not immediatly add to the wort. You just do not get the added benefit of
that sudden burst of energy. We also recommend that you attemperate the
rehydrated yeast to with in 15F of the wort before adding to the wort.

Warm yeast into a cold wort will cause many of the yeast to produce petite
mutants that will never grow or ferment properly and will cause them to
produce H2S. The attemperation can take place over a very brief period by
adding, in increments, a small amount of the cooler wort to the rehydrated
yeast.

Many times we find that warm water is added to a very cold container that
drops the rehydrating water below the desired temperature.

Sometimes refrigerated, very cold, dry yeast is added directly to the warm
water with out giving it time to come to room temperature. The initial
water intering the cell is then cool.

How do many beer and wine makers have successful fermentations when they ignore all the above? I believe that it is just a numbers game. Each gram
of Active Dry Yeast contains about 20 billion live yeast cells. If you
slightly damage the cells, they have a remarkable ability to recover in the
rich wort. If you kill 60% of the cell you still have 8 billion cells per
gram that can go on to do the job at a slower rate.

The manufacturer of Active Dry Beer Yeast would be remiss if they offered
rehydration instructions that were less than the very best that their data
indicated.

One very important factor that the distributor and beer maker should keep
in mind is that Active Dry Yeast is dormant or inactive and not inert, so
keep refrigerated at all times. Do not store in a tin roofed warehouse
that becomes an oven or on a window sill that gets equally hot.

Active Dry Yeast looses about 20% of its activity in a year when it is
stored at 75 F and only 4% when refrigerated.

The above overview of rehydration should tell you that there is a very best
way to rehydrate. It should also tell you where you are safe in adapting
the rehydration procedure to fit your clients.
 
Thanks for that Reg. That should clear up any thoughts on the matter. I always knew you shouldn't put sugars in the rehydration water, but I didn't realise it was actually detrimental to the yeast if you did. Might be the answer to your problem bl@de.

Cheers,
Pete

:chug:
 
Wow thanks guys, that stuff is very informative and I shall not be going any further than 30 degrees, I shall not be listening to one brew place in the future as this is now the 3rd thing I have found I am doing wrong that they have told me to do.

The company shall remain anonymous as I wish not to stir up trouble.

Thanks again.
 

Latest posts

Back
Top