TheCarbinator
Well-Known Member
- Joined
- 16/6/12
- Messages
- 217
- Reaction score
- 16
So I bought the following items a couple of weeks ago to make up my HERMS temp controller.
Auber PID Model: SYL-2352P
http://www.auberins.com/index.php?main_page=product_info&cPath=1&products_id=4
Temp probe (PT 100)
http://www.auberins.com/index.php?main_page=product_info&cPath=20_15&products_id=261
Also bought the appropriate SSR and heatsink to suit.
I had them hooked up by an electrician while carefully reading the instructions.
Then when I turn it on, the temperature is showing (as far as I can work out) minus two hundred and something degrees.
That was after I changed the settings to celcius.
Then I swapped the two red wires on terminals 3 and four.
Now it is showing 636 degrees celcius (as in photo)
.
Has anyone come across this?
Any advice would be great!
Cheers
Andrew
Auber PID Model: SYL-2352P
http://www.auberins.com/index.php?main_page=product_info&cPath=1&products_id=4
Temp probe (PT 100)
http://www.auberins.com/index.php?main_page=product_info&cPath=20_15&products_id=261
Also bought the appropriate SSR and heatsink to suit.
I had them hooked up by an electrician while carefully reading the instructions.
Then when I turn it on, the temperature is showing (as far as I can work out) minus two hundred and something degrees.
That was after I changed the settings to celcius.
Then I swapped the two red wires on terminals 3 and four.
Now it is showing 636 degrees celcius (as in photo)
.
Has anyone come across this?
Any advice would be great!
Cheers
Andrew