Crusty
Well-Known Member
Hi guys,
I have installed a ramp, soak. kiln, ssr PID, SYL-2352P from auberins & having trouble with understanding how it works.
I have it setup with PT100 probe, 3 wire. White on 5, two reds on 4 & 3. When switching it on, the alarm 1 light is lit up & the PV is reading 1227, my desired 66deg is set on SV. After a few seconds, it switches between the set point 66 & a green stop flashes. I did have a problem in the past with two wires coming away from the probe & auberins directed me as to which way to solder it back together.
Anyone have any ideas to get me going?
Cheers
I have installed a ramp, soak. kiln, ssr PID, SYL-2352P from auberins & having trouble with understanding how it works.
I have it setup with PT100 probe, 3 wire. White on 5, two reds on 4 & 3. When switching it on, the alarm 1 light is lit up & the PV is reading 1227, my desired 66deg is set on SV. After a few seconds, it switches between the set point 66 & a green stop flashes. I did have a problem in the past with two wires coming away from the probe & auberins directed me as to which way to solder it back together.
Anyone have any ideas to get me going?
Cheers