Mtc 2120 - Operating Instructions

[MVZOOM]

HI All, anyone have a copy of the operating instructions for this temp controller? I have a wiring diagram, however can't figure out how to set it up.

Cheers - Mike

 

[Jye]

You can download them from here.

They are great little units and mine has been going strong for about 1.5 years now.

 

[MVZOOM]

Awesome, thanks Jye - I searched pretty hard and couldn't find. I have a Mashmaster also, it's been going great guns for about 18 months too - all good!

Cheers - MIke

 

[andypaskin03]

Hi does anyone if this manual is still available the previous link is now dead?

Thanks in advance.
Andy

 

[sp0rk]

Is this what you're looking for?
http://www.chromalox.com/catalog/resources/im-pk-2120.pdf

 

[andypaskin03]

Hi im not sure it is, thanks for trying though. I couldnt upload a photo to show you but if you google MTC-2120 it will come up, but i can not find any instructions anywhere.

 

[andypaskin03]

Hi im not sure it is, thanks for trying though. I couldnt upload a photo to show you but if you google MTC-2120 it will come up, but i can not find any instructions anywhere.

 

[sp0rk]

I think I found it in Chinese...
http://passthrough.fw-notify.net/download/539192/http://www.e-elitech.com/uploads/soft/manual/mtc-2120s.pdf

 

[andypaskin03]

Thanks for trying i think the link is down

 

[hexman]

Sorry to dig up an old thread, but.... every once in a while I find myself needing to find this info again and spend hours searching and translating Chinese manuals, so here are the functions for future reference:

F01 - Upper temp limit(will turn on/off the heat/cooling at these temps to stay in this range) (-39-50c - factory default -10)
F02 - Lower temp limit (will turn on/off the heat/cooling at these temps to stay in this range) (-40-49c - factory default -20)
F03 - Temperature adjustment if probe reports incorrect temp (+-5c - factory default 0)
F04 - Compressor delay (0-9 min - factory default 3)
F05 - Alarm threshold (0-20c factory default 15)