Mini Keg Discussion / Mods / Show Off - Dedicated Thread

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I won't run out till the MKIV bulk buy.

Then I was going to buy big. Not sure after that.
 
hotmelt said:
If you've got a spare poppet valve .
attachicon.gif
20161212_163426.jpg1.jpg
attachicon.gif
20161212_163501.jpg2.jpg

Attach disconnect first ,place spring in centre ,line up tap and push together.It's a bit fiddly to put together but it works ok.
This one might be better if you have one.
Can confirm this works, I used the bottom universal type one
Has anyone else noticed the taps flow at a tiny trickle if you have over 100kpa/14psi in the tank?
I took my tap apart and lubed all orings with keg lube, don't know if it was just gummy from manufacture and my quick cleaning
 
Is there a reg out there which is set to a single pressure - ie 10psi? I realised lately that I only ever use my minikeg reg at pouring pressure so I don't really need an adjustable one, and I figure a non-adjustable reg would be cheaper / less prone to breakage (due to less moving parts)
 
Just need to find a better esky, 5lt kegs sitting on a piece of timber here.

DSCF7448.JPG
 
Yob said:
I put a bit of time into decorating mine



:lol:
you should setup a bulk buy for your decorating skills... you could sell a range of custom made stickers :)
 
If it has been named yet, What is the name of your brewery Yob?
 
Back
Top