MashMaster fluted mill and HD drill complete setup Brisbane

[Smokomark]

Mash Master twin fluted stainless geared roller mill. comes set up ready to use with hi torque, low speed drill. 0-500 rpm 1050w 13mm keyless chuck. Very little use.
Original perspex hopper and 30lt fermenter with funnel - holds approx 15kg of grain. Crushed grain drops into 55lt esky

$300 ono located inThornlands,


MillMaster MiniMill Specifications

130mm (5"approx.) precision machined rollers
39mm (1 1/2") diameter rollers
26 flutes per roller
420 Hardened Stainless Steel Rollers as Standard high corrosion and wear resistance
12.7mm (1/2") drive shaft keyed for easy motorization, drill drive or hand crank
additional 3 flat triangular shank drive shaft designed to fit a 3/8ths drill chuck for improved torque and centering.
oil-impregnated sintered bronze bushings, carry a higher load, need less maintenance, and damp vibration better than their rolling-bearing counterparts.
Strong aluminum frame

 

[Smokomark]

Price reduced NOW $250

 

[Maheel]

upgrading Mark ?

I have a gen 1 no flutes MM mill

this is a bargain, maybe i should buy it and re-sell mine !!

 

[altone]

upgrading Mark ?

I have a gen 1 no flutes MM mill

this is a bargain, maybe i should buy it and re-sell mine !!

I don't need a mill but if it was in Melbourne and I hadn't spent all my money on fixing and moving house I'd buy it for sure.

 

[Smokomark]

upgrading Mark ?

I have a gen 1 no flutes MM mill

this is a bargain, maybe i should buy it and re-sell mine !!

I've had another mill for well over a year now, that I got with a heap of other stuff. It's a big arse monster mill with motion dynamics motor and a huge all steel hopper that holds 15kg plus. Don't really need two Mills.

 

[Bbowzky1]

I've had another mill for well over a year now, that I got with a heap of other stuff. It's a big arse monster mill with motion dynamics motor and a huge all steel hopper that holds 15kg plus. Don't really need two Mills.

Sounds like I need something like your big mill.
Mashing 40-60kg at a time with 5kg hopper does ya head in.

Is it still just a mash master fluted mill with motion dynamic controller and bigger custom hopper? This is what I was considering doing?

Cheers