thanks for that warm beer, now try reading my post again - anyone done this mod without replacing post, ie cutting the top out wider? - and yes i did use the search function.
Okay, I'll take that one on the chin. Was hung-over and not reading too gooderer.
I've just (as in last week) upgraded my Keg King Kegerator from a 2 tap font to a 3 tap font. I don't know anything specific about the Kegmate, but image they're a very similar design to the KK ones, if they're like
this one from Craftbrewer.
I bought a new chrome font, pre-drilled with the 3 holes, and replaced the old font. Is it the font you're wanting to expand upon, or are concerned about cutting into the top of the fridge unit? I
think the single tap fonts are a smaller diameter than the 2/3 tap ones. It was still pretty fiddly in there with the larger diameter font, and I ended up only being able to hand-tighten the lower 2 shanks, as I didn't have a 27mm ring spanner handy.
Hope this helps, and apologies for the grumpiness yesterday.