Help With Making Steel Brewing Unit

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

SJW

As you must brew, so you must drink
Joined
10/3/04
Messages
3,401
Reaction score
211
I want to make a simple 2 level brewing unit. The lower level just high enogh of the ground so the boiler can dump into the fermenter, on the floor. And the second level just high enogh so the mash tun can dump into the boiler. Both are S/S kegs so the O/A height would only be about 1200mm and no wider than the two kegs together and no deeper than a keg.
My question is would 25x25x1.6mm think square hollow section be strong enough to hold all this gear with water and or wort in it? I dont plan on welding as I want to use these new type of conectors. So what do u think?


STEPHEN
 

Latest posts

Back
Top