Grain Crusher - Drill Attachment

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

wedge

Well-Known Member
Joined
21/11/03
Messages
528
Reaction score
0
Guys,

i've got a barley crusher that i have only used sadly once. :eek:

But i'm going to fix that. Want i want to know is how i can use the drill to run my crusher rather than my arm.


Can anyone out there help me. The bit attached to the roller is round, (i think), but that being said i have seen people attach it correctly.


Can you help me?
 
yep undo the hadle of the bc and put the 8 mm roller attachement in the drill chuck and tighten then go for it
 
Jazman said:
yep undo the hadle of the bc and put the 8 mm roller attachement in the drill chuck and tighten then go for it

Got a flat file? Filing three small flats on the end of the shaft (look at the pictures on the Crankenstein website) will ensure the drill chuck doesn't slip. :D
 
Back
Top