Having a cleanout.
Have this plastic conical from a project that never got completed.
It is 50L, with a side port and bottle port. Both with screw in fermenter taps.
The top has an access hole suitable for a bung and airlock. There is a small section where there is a small hole where the mould wasn't prefect. A little resin could seal that.
There is also a port on the side that was intended to be for a chiller unit. I was going to do lagers in this. For chilling I was planning on using an IceProbe Thermoelectric Water Cooling Device (like the attached graphic).
It is 650mm high (not including the bottom tap) by 400mm wide.
Prefer local pickup (Cherrybrook/West Pennant Hills - Sydney), but if there is no one local interested will post at buyers expense.
Asking $80 ONO. First in (via PM) best dressed.
Beers,
Doc
Have this plastic conical from a project that never got completed.
It is 50L, with a side port and bottle port. Both with screw in fermenter taps.
The top has an access hole suitable for a bung and airlock. There is a small section where there is a small hole where the mould wasn't prefect. A little resin could seal that.
There is also a port on the side that was intended to be for a chiller unit. I was going to do lagers in this. For chilling I was planning on using an IceProbe Thermoelectric Water Cooling Device (like the attached graphic).
It is 650mm high (not including the bottom tap) by 400mm wide.
Prefer local pickup (Cherrybrook/West Pennant Hills - Sydney), but if there is no one local interested will post at buyers expense.
Asking $80 ONO. First in (via PM) best dressed.
Beers,
Doc