Force gassing

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

DangerousDave

Well-Known Member
Joined
23/6/10
Messages
92
Reaction score
0
Hey guys back after a long time can't remember when force gassing is it 300 psi and roll it on it's side for 20 secs that's what I remember any advice appreciated
 
@DangerousDave Maybe a typo.

Not sure your reg will get you to 300 psi, directly connect to your CO2 cylinder and you will, briefly before catastrophic keg failure.

I would read the link from philrob or just set regulator to required serving pressure and wait a couple of weeks.
 
try 300 KPA 300PSI would be a bomb
 
I had to force carb a keg recently. It had been on serving pressure for a fortnight and when i drank it it was flat. I increased pressure to 40 psi and rolled the keg on its side for 3 minutes and it was fine to drink. I'm unsure of why it didnt carb initially as i have been using this method for a year or so without any issues.
 

Latest posts

Back
Top