Truman42
Well-Known Member
- Joined
- 31/7/11
- Messages
- 3,973
- Reaction score
- 608
Im looking at switching from batch sparging to fly sparging but due to my brew frame design I am unable to get my HLT high enough to gravity feed into the MT.
I have two brown pumps and was looking at setting them up so one pumps water from the HLT via a sparge arm into the MLT while the other pumps out of the MT into the kettle.
Is anyone else using brown pumps to fly sparge? If so whats the best way to set this up with regards to flow rates etc? Im assuming at full flow it would be too quick for a decent fly sparge. But not sure how slow I need to reduce the flow rate too and if I am better off using taps on the outlets or some sort of voltage control to slow the pumps down.
Any advice appreciated.
I have two brown pumps and was looking at setting them up so one pumps water from the HLT via a sparge arm into the MLT while the other pumps out of the MT into the kettle.
Is anyone else using brown pumps to fly sparge? If so whats the best way to set this up with regards to flow rates etc? Im assuming at full flow it would be too quick for a decent fly sparge. But not sure how slow I need to reduce the flow rate too and if I am better off using taps on the outlets or some sort of voltage control to slow the pumps down.
Any advice appreciated.