Controller wiring help

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

snails07

Well-Known Member
Joined
5/2/14
Messages
121
Reaction score
36
I'm building a mash temp controller using a RaspberryPi and Craftbeerpi and just wanting to make sure this 240v wiring is 110% correct.

I will be getting my sparky neighbour to check it over once it is done but just wanting to try to get it right before i take it round to him.

It will be powering a keg king 2200w element that is installed in the kettle.

1485241562285.jpg


1485241570131.jpg
 
Not even gonna touch this one. Show it to your sparky mate first.

Computer says no.
 
Haha, thought that might be the response.
The sparky will be checking it over
 
@Ducatiboy stu - yes the terminal block will be mounted to the case and what do you mean by "fix this bit" in the first image? Make sure it is secure?
 
Back
Top