Camlock Males

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Crusty

Well-Known Member
Joined
29/6/08
Messages
2,625
Reaction score
607
Location
Gulmarrad, NSW
Just a quick question.
I need a couple of different size camlock males for the CIP system I'm setting up. Are the 1/2", 3/4" & 1" all the same size?
The male end where the female locks onto? I'm needing to run 1" camlocks, male threads from my pump but from the butterfly valves on the unitank, I'll have to get a couple of 1.5" tri clover to 3/4" bsp so I'll need a couple of 3/4" male bsp thread camlocks to suit.
I would assume they're all the same size but not 100% sure.
Cheers
 
I'm not expert but I think the male end matches the BSP size. You can buy reducers, etc.
 

Latest posts

Back
Top