Brew Hardware - pumps and fittings

[shoobs]

A bunch of assorted brew hardware.

• 2 x Topsflo TD5 24 V pumps. These were custom built for me with a 0-5 V speed control line broken out. Note, they will not run without the 0-5 V signal supplied.
• Power supply and speed controller PCB for the above. Not assembled or tested. Would suit someone with some electronics knowledge.
• 3 x Beerbelly bulkheads
• Assorted fittings, all stainless
  • 3 x 1/2" BSP female-female elbows
  • 1 x 1/2" BSP male-female elbow
  • 2 x 1/2" BSP male-male camlock
  • 1 x 1/2" BSP female-male camlock
  • 2 x 1/2" BSP male-hose tail fittings
  • 1 x 3/8" BSP male-hose tail fitting
  • 2 x 1/2" BSP male-16mm compression fitting
• 6 x custom camlock to hose tail fittings. They fit 1/2" ID silicone hose great, without the need for cable clamps.

Honestly not sure how to best assign prices to these because they're a big old mish mash of stuff. I'd prefer to keep stuff grouped together as listed, where possible. Make me an offer.

 

[Meddo]

Will PM in a sec re Topsflos

 

[shoobs]

Just to post some prices that I offered Meddo:
- Pumps are $100 each, or $180 for both.
- Speed controller PCB, bunch of components and Meanwell PSU (24 V, 4.5 A) is $30 if you take both pumps.

 

[Meddo]

The pumps don't quite work for my project but that's a stone cold bargain.

 

[finley44]

Just to post some prices that I offered Meddo:
- Pumps are $100 each, or $180 for both.
- Speed controller PCB, bunch of components and Meanwell PSU (24 V, 4.5 A) is $30 if you take both pumps.

Are these parts still available

 

[bill1]

Interested in the camlocks Shoobs (right angle female to tail and male), but are you selling them as separate lots?

 

[Moog]

I may be interested in one of your pumps and the control circuits to match, how much?? ( & post to south Queensland)

 

[Gollywog]

Pm sent.

 

[shoobs]

Sorry folks, everything has sold at this point.