Search results

Yeah, need spacer (as per link above), or use a flexible coupler. Mounting solid without spacer will shag the bearings in the mill or drill or both. Happy to print off mounts + spacer for people $10pp (just to cover materials/ electricity/time) in grey petg.

https://www.thingiverse.com/thing:3120976 :)

Thanks - yes I could spin it around, however the 32A point is on that side of the door - and currently I can just pump waste to a drain point just out of shot (could use a couple of longer hoses I guess). Will knock up a 3d printed "sun visor" first and see how that fares :)

Yet another electric brewery build. Gave me a good excuse to buy a welder :) First brew going through now, everything behaving as it should (a miracle given the number of wires inside). 90L HTL + Kettle, 50L MLT with autosparge. Used the bigger kegking pumps as I was worried about flow rate...

The whole set uses about 90g of filament. PETG is roughly $36/kg so roughly $3.25 in materials (mind you that takes about 12 hours print time with PETG) - PLA is a bit cheaper $23/kg so $2 in material and prints faster - but has a lower glass transition temp so might get a bit melty if left in a...

Finally got around to buying a mill (what a fine piece of engineering this thing is!) and knocked up some 3d printed mounts to attach it and ozito drill to a small table. (Please ignore the printing zits on the side mount - I was tuning print settings... badly) Anyway - have uploaded the...

Had 2 of the 88L pots delivered this morning, moving from biab to 3v (slowly) Internal measurements 46.5 x 51 cm = 86.5 ish L Wall thickness is 1.34 according to micrometer - and then taking into account the bend radius of the pot and the diameter of the micrometer probe lands it exactly on...

PM sent! Please consider sold for $300PP if condition confirmed as per PM :D