Help Support Aussie Homebrewer by donating:

Recent Activity

Activity stream for all registered members at Aussie Home Brewer.

  1. breakbeer replied to the thread FS: Plaato Digital/WiFi Airlock.

    Sold to nosco pending payment I’ll PM you mate

    22/11/18 at 9:41 AM
  2. breakbeer liked Nullnvoid's post in the thread FS: Plaato Digital/WiFi Airlock.

    Same Nosco as bought the sodium perc? If so if you can arrange with breakbeer the payment I could always pick up and bring to the...

    22/11/18 at 9:38 AM
  3. The Mack replied to the thread EOI Oxygen scavenging caps/crown seals.

    1. Altone 1000 will take an extra 500 if it's needed to seal the deal 2. BBQzookeeper 1000 3. ABG 500 4. Coalminer 1000 5. Half-baked...

    22/11/18 at 9:13 AM
  4. Nullnvoid replied to the thread FS: Plaato Digital/WiFi Airlock.

    Same Nosco as bought the sodium perc? If so if you can arrange with breakbeer the payment I could always pick up and bring to the...

    22/11/18 at 9:10 AM
  5. Grmblz replied to the thread EOI Oxygen scavenging caps/crown seals.

    I'll take 1000. Probably wont use them all in 2 yrs but it's a good cause. Cheers G

    22/11/18 at 9:05 AM
  6. Meddo replied to the thread Ideas for closed transfer from basic HDPE fermenter.

    Get one of these bottling wands and cut a two inch section off the main stem. Jam that section in the fermenter tap and some 8mm beer...

    22/11/18 at 9:04 AM
  7. nosco replied to the thread FS: Plaato Digital/WiFi Airlock.

    So similar to a Tilt? Well dam I think Ill take you up on that offer. I can pick during the day in Cockatoo or from Carrum Downs on the...

    22/11/18 at 8:55 AM
  8. breakbeer posted a new thread.

    FS: Plaato Digital/WiFi Airlock

    I backed the Kickstarter for this product around 2 years ago & they finally arrived this week. Money’s tighter than it used to be &...

    IMG_6158.JPG

    Forum: Buy and Sell

    22/11/18 at 8:48 AM
  9. Abird89 replied to the thread GUTEN.

    They doing that for everyone? Got one of the first, before the jackets were around. I need my next lot of little supplies ordered anyway...

    22/11/18 at 8:47 AM
  10. S.E replied to the thread Sending homebrew interstate.

    That’s what I would do but check first that the airline is happy taking kegs. You perhaps may have to open the lid to show them its not...

    22/11/18 at 8:47 AM
  11. krz replied to the thread GUTEN.

    I picked up my jacket yesterday and also the whirlpool arm. As I had purchased the Guten 50L from them some months ago, they gave me the...

    22/11/18 at 8:38 AM
  12. altone replied to the thread GUTEN.

    Err what are you talking about here? The last lot of posts were about the Guten jackets. Oh if it's the whirlpool arm I'm with you on that.

    22/11/18 at 8:33 AM
  13. altone liked S.E's post in the thread Ideas for closed transfer from basic HDPE fermenter.

    Yep, done it no problems. Its a bit slow but if you go away and forget about it the beer will only fill up the gas line to the level of...

    22/11/18 at 8:30 AM
  14. S.E replied to the thread Ideas for closed transfer from basic HDPE fermenter.

    Yep, done it no problems. Its a bit slow but if you go away and forget about it the beer will only fill up the gas line to the level of...

    22/11/18 at 8:22 AM
  15. razz liked altone's post in the thread Tri clover.

    Dammit! I was just there for an emergency CO2 swapover, never even looked - ah well no hurry on the tri clover. At least now I've got a...

    22/11/18 at 8:22 AM
Loading...