Recent content by Maverick1

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    Bubbles in beer line after the keg and before Faucet

    Okay got my setup going, used on the faucet and ball lock about 2 inches of 3/8th with a john guest 3/8 stepdown to 3/16th. 2.5m in length is the 3/16th and pressure set at 13psi@3deg temp. Faucet has flow controls on them and are set almost fully open. If I was to shorten the length will it...
  2. M

    Bubbles in beer line after the keg and before Faucet

    Thanks Guys, busy sourcing 5mm soft tubing and will keep u posted once up and running! 3/8 which I'm running now is very rigid too, supplied by Brewcraft and keeps pushing the door open, never rains!
  3. M

    Bubbles in beer line after the keg and before Faucet

    Thanks guys, spoke to a gentleman that installs and looks after all the draft equipment for South Africa Breweries and he reckons too that I must install 3/16(5mm) and says I must drop the temp too around 3 - 4degress. What flow rate do u guys use damoninja
  4. M

    Bubbles in beer line after the keg and before Faucet

    Using 3/8 ID Plastic beer line and at the moment the length is 1.5m, and I'm having bubbles in the beer line before the tap and after the keg. Used the crozdog_balancing_table.xls.xlsx 126.76KB and its says I must use 11meters of beer line for 5deg and 1,8volume of Co2 and I used o height as...
Back
Top