Recent content by Logman

All gone.

3 Sold....all 5 for $300 or $70 each.

8 Corny Kegs - Worongary, Gold Coast. All kegs are identical with same post spanner size. New o-ring service kit fitted within the last couple of months. No dents. $70 each or all 8 for $500.

I'm looking to replace the washers that are just below the thread inside the ball lock quick disconnects but can't find an Aussie retailer that stocks them, seems to be only US stores that sell them...anyone know if they are available here?

Hi Mark, it's about the size of a dollar coin, but I think it's warped to that size and should be the size of a two dollar coin. The only gear the taps have been used with is ball lock QD's and standard shanks. In the picture of the O-ring kit there is one that looks like this should I think...

As you can see in the picture the o-ring has warped and flattened out. I think it's so warped it won't go back into the spout. I'm guessing that the other tap spout has no o-ring because it's been lost originally at the shop because I got a stout pourer for that tap. Ordered a couple of o-ring...

I put all 4 taps back together and no leaks. I'm 99% sure it came from the intertap, the Celli's have been disassembled 1000 times. The spout was where I kept going back to but it seems too big, it's quite a chunky o-ring (it's a 4 sided ring by the way) - I'll have another go around the spout...

I've got two Celli taps and two Intertap flow control, both which I've cleaned a million times. Soaked them overnight with some ball lock connects. I was scrubbing them with a bristle pipe cleaner and I think this O-ring must have come out of one of the Intertaps but not really sure....and can't...

No problem, PM sent. MASH TUN GONE.....

Mash Tun and HLT to give away. Mash Tun holds temperature fine, I only got a new one because I'm making a new stand. Have made copious amounts of beer with it :drinkingbeer:. HLT has a hole drilled for a 1 1/4 BSP element to be fitted. Also has 2 ports with bungs in there that can be used for...

Couple of mash tun bargains Brisbane

Nice, thanks! I thought the originals were cylinder shape, seems like they were a tougher silicone too 👍

Cornelius...are the Mytton Rodd tubes a different size?

Ball lock kegs. Had a bit of a look on American forums and found this, I might just get the measurements and buy round orange silicone ones from an o'ring shop. The ones I originally had were collar shape and silicone, that's what I'm after, the ebay ones I've been getting are collar shape but...

I've been buying dip tube and gas tube o'rings from ebay for the last year or so and they're about 7 bux for 10 but they are useless. The washers that were originally on the kegs when I bought them second hand years ago were much harder (I think a few were red). They were firmer silicone, you...