Thanks for the comments.
How long do you think it would it take to get to 10psi? It had approx. 12 hours from when I attached the valve and it was till on 0.
Hi Guys
First time using a spunding valve so excuse the ignorance. I set up the valve to 10psi using a gas bottle last night (working fine) then attached it to the fermentasaurus. The brew was fermenting nicely (plenty of bubbles in the blow off tube) when I attached it.
When I checked this...
Thanks for the info Mark re cleaning. I currently remove the spear, soak with PBW, scrub if necessary, rinse, and sanitise. Seems to work ok.
My uncertainty was about my current method I use for closed transfers. Razz said my process is fine (ie leave the gas port on the coupler open) if the...
So I'm guessing that if I pressure ferment so the beer is not flat, I would need a spunding valve on the gas side of the coupler? If so, do you know why this'd be necessary?
Hi Guys
I have Sanke kegs that use a S type coupler. I'm not sure if I am doing my closed transfer correctly. Can I leave the gas port open (ie without the "duck bill" check value) or do I need to use a spunding valve? My theory is that the keg is full of Co2 which will be displaced when the...
Why would you need a Digiboil to control it? Couldn't it just be turned and off by the wall switch (or a switch on a power board) and temp control via temp controller?
Approx how quick can you boil 60 litres with the 3kw element?
Thanks. I was planning to drill a hole in the side of the kettle for the element and another hole for the thermowell.
Control would be via temp controller from Kegland or similar.