Recent content by Enkie

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. E

    iSpindel Digital Hydrometer

    Gents and Ladies, I received a new Wemos D1 mini Pro from the guy I bought the whole set from. Inmediately before desoldering and soldering I tried to flash this Wemos, with a positive result. It was apparently a faulty Wemos causing me problems flashing. After it was in pace on the board, I...
  2. E

    iSpindel Digital Hydrometer

    I have the same problem, somebody solved this problem during flashing? It does nothing after you push the flash button. The logg shows: Note:Detect serial port changed. Note:Auto MAP serial port.Port-->COM3 Note:Serial port connected. Note:Begin find ESP8266. the following...
  3. E

    iSpindel Digital Hydrometer

    If I understand correctly I need to resolder the 0 ohm resistor into the green position. In that case the ceramic antenna is not working anymore and have to buy an external antenna like in the attached picture? Only if the signal is not sufficient at the moment. Can you also help me out with...
  4. E

    iSpindel Digital Hydrometer

    Hi Bee2Gee, thank you for your reply, first question is when not removing the diode as described on the website earlier mentioned, what is the on position? How it’s now on the picture or in the other position? Second question, what do you mean with the 0 ohm resistor, can you point it out, on...
  5. E

    iSpindel Digital Hydrometer

    Diode removal - Wemos D1 mini pro Dear all, I am new to the forum, I bought a set to solder the ispindel yourself from someone containing all parts. I have the cherry phllip 4.0 board and the Wemos d1 mini pro (brand: rainsun), this is where my question is. I want to remove the diode to prevent...
Back
Top