Recent content by Eater

I would be keen on a Premium pass, have got a Tilt to assist in testing any new releases

As an idea HBHB you could glue a thick piece of wood to the back of the fridge with something moisture and cold resistant (silastic product maybe?) and than bolt the included wall mount to that id rekon. This is of course if the fridge is a dedicated fermentation box.

"Live on vegemite, ya never minded never minded to live on vegemite" Liberate by Disturbed

PM Sent

Highly recommend doing just that (Bamberg) or if you are after more pretty places, with good a good beer hall try Tegernsee for an overnight stay

I copied mine from Phillip the Brewers setup from BeerSmith2 forum Attached here for your convenience (rename to .bsmx) Has seemed to work for the last 4 brews done ;)

So I got a nut and washer, back in action tomorrow Thanks for the quick reply and offers of help ;)

Sure $100 in scrap and around $2400 in postage and handling ;) I have torn my entire house apart looking for it, missus was ready to leave me there and then over it as i ranted and raved. No doubt it will turn up in the veggie compartment of the fridge or other places i never ever use

Batz I owe you a frosty beer or three :beer: Havent been to BaBBs yet, was hoping to have actual homebrew before lobbing in. Ill try across the road at bunnings first then let you know.

Gday Short story - Tragedy, have lost the wing nut to secure the bow down on my malt pipe in the 20L Braumeister Does anyone know what size and thread the rod is so I can get a nut and washer in the short term, and if there is a replacement stainless wing nut i can get from either Speidel or a...

Local federal member Wayne Swan, email sent.

@Murdoch and Malted Thanks for the further explanation and other methods of getting a tap on the BM I also read the american article link and I think that is where the majority of my confusion arose from.

Cheers Owe you a beer for settling my confusion

Thanks Murdoch Any idea what the correct terminology is or can I just say plainly to them "I am looking for a straight 3/4" to 1/2" tapered thread in a reducing nipple" without looking daft.

So am I right in thinking you have a 3/4" Straight or parallel type thread to 1/2" tapered thread to suit the 3 piece valve If thats the case, where did you get it from? And what is the correct terminology (NPT, BSP, BSPM etc) I am thinking of following your example but am having trouble...