Recent content by bradwhite087

I was thinking of going the Cherry Philip design as it seems slightly easier. Do you have the parts list required, at least a link to the smaller battery charger module required? Cheers

I'm trying to get the parts list, but it doesn't load. I suspect the shopping list has expired. Any chance you could send it again?

What issues did you experience?

servo motor to control gas valve

Pilot light

Valve for pilot light control

PID Automated BIAB System

G'day fellow brewers, I thought I would upload my automated gas PID BIAB system. It has been a long and somewhat painful process which at some point I thought was not going to be successful, but with a little persistence I finally got there :D If anyone is thinking of going down the...

Cheers Bribie G

Thanks for the info guys, I may just give the sleeping bag a go. Where can you purchase a sheet of metallised rubber from?

I did try it with a old blanket. It did manage to hold temps a lot better than using nothing. I do find it hard to put the blanket on with everything so hot and I am a little hesitant to put the blanket on while the burner is going for obvious safety reasons.

G'day fellow brewers, I have recently had fluctuations in my mash temps for my BIAB system. I want to try and get the temp within 1-2 degrees during the mash stage. A little about my system: (see pic below) 1. I have been recirculating the wort from the bottom back through the top using a...