Search results

Stellarclean (PBW)

Nope only Stellarclean (sod perc) and Stellarsan has been in contact with the bowl we had the lids in. I’ve got a few boxes with older cans in them. I’ll setup a bit of a test/trial next time I’m canning and if I find a reproducible problem set, will drop them in next time I do a pickup.

Well I can’t guarantee it’s Sulfur that we smelt but it certainly had that eggy/fart type smell. Our of curiosity looked up what’s in the Stellarsan; Dodecylbenzenesulfonic acid ; Linear Formula: C12H25C6H4SO3H What epoxy do you use does it have hydrogen in the formula as it could be formation...

Hi @KegLand-com-au was doing a canning run yesterday using full aperture black 500mL cans you sell. We noticed a VERY strong Sulfur smell from the lids sitting in a bucket of sanitizer. We tried different containers, changed the sanitizer (mixed as per directions Stellarsan using de-chlorinated...

If this went ahead, what would the timeline be before it’s available on shelf? Just sussing whether to use threaded model and upgrade head later or hold out until full unit available.

Ok noted. Can the MFL fitting be unthreaded from the cast plate or are they to be considered permanent and cast into the plate?

@KegLand-com-au I was hoping to add carb caps or ball lock liquid posts to my cast aluminium plate chiller so I can connect and disconnect Nukatap minis to it. Do you have an FFL to 6mm tube fitting (so the carb cap can push into that fitting)? Like this one that is 8mm tube… or do you have carb...

Ok thank you!

https://www.kegland.com.au/products/65w-stainless-head-magnetic-drive-pump-with-3-4-bspt-threads-easy-remove-wing-nut-head

Hi @KegLand-com-au are you planning on offering a complete 1.5" TC head for the 3/4" sized wort pump?

@KegLand-com-au is there a 1.5" Triclamp ported version of the larger 3/4" brewing pump head on the horizon by any chance?

The disconnects and posts are NOT interchangeable. Liquid is for liquid. Gas is for Gas. The carbonation caps are the ones that are interchangeable....

No like this so it doesn’t need thread tape and can be removed quickly…

Pride drop $200!!!

Any movements on a 1/2” quick swivel that goes to a 1.5” or 3/4” Triclamp connector?

It was actually one of the best beers I have made and I have had it on the "to brew" list for a while. Granted back then my palate and brewing abilities were less developed than they are today, but I am keen to brew it again when there's a slot in the fermentation cycle. Yeast would have been...

Greensborough home brew

@KegLand-com-au any chance of you selling the flexi-arm seals as replacement spares? First mash I did I dropped the seal into the mash bed (got it at the end) as these fall out very easily, I’m certain I’ll lose some along the way so good to have a bag of them handy please. Also any updates on...

Fresh is best, let's move on :)

My mate checked and said there was no ice at all! Is there a small font fan to blow up the tube? Or does it just take a tiny bit of air from the main large fan to blow up the tube? My mate said upon close look the tube is just open on the other side of the shroud/panel so there is no dedicated...